WARNING!
This device may not receive the system
status properly if it operates within a few feet
of the 5881 RF receiver.
SYSTEM STATUS INDICATIONS TABLE
LED
LED Condition
Sounder
System Status
Red On
Steady
On Steady
Flashing
Flashing
Flashing
2 Beeps
3 Beeps
Pulsing
Steady
Silent
Armed Away or Maximum
Armed Stay or Instant
Fire Alarm in progress
Armed, Burglary Alarm in progress
Alarm Memory
Green On
Steady
Flashing
1 Beep
Silent
Disarmed, Ready to Arm
Disarmed, Not Ready to Arm
Yellow (right)
Flashing
Silent
Indicates RF transmission
Red & Green
Alternately Flashing
Silent
In Enter House ID Mode
Green Flashing
Flashing
Pulsing
Silent
System in Trouble
System Not Ready
MULTIPLE BUTTON OPERATIONS
The 5804BD can generate the same responses as
keypad panic key pairs of [
✶
] + [#] and [
✶
] + [1] by
depressing “A” + “C” and “B” + “D” button pairs,
respectively. You must depress the button pair for at
least two seconds for the 5804BD to recognize the
button pair command. These button pairs allow the user
to activate panic, fire, and medical alarms depending on
control panel programming.
Failure of Replaceable Batteries
This wireless key has been designed to provide several years of battery life under normal conditions. The
expected battery life is a function of the device environment, usage and type. Ambient conditions such as high
humidity, high or low temperatures, or large temperature fluctuations may reduce the expected battery life.
This device will report a low battery condition to the control panel as a trouble condition, when the batteries
need to be replaced. In addition the yellow LED will not flash when a button is pressed. However, if the device
is unused for a long period of time, it may fail to operate as expected. Regular testing and maintenance will
keep the system in good operating condition for the lifetime of the product.
IMPORTANT!
This wireless key is intended as a convenience to the user and should not be considered as a
life safety device. If life safety is important, please select a supervised wireless key (e.g. type 5802MN).
Low-Battery Indication
When the unit goes into a low battery condition, the yellow LED will not flash when a button is pressed.
Change both batteries immediately.
TO INSTALL / REPLACE BATTERIES
1. Remove the screw from the case back.
2. Remove case back by using the blade of a small screwdriver to pry open.
3. Place batteries in case back locations (see diagram). Use CR2430 or DL2430
Lithium battery only.
4. Close the case by snapping case front and back together.
5. Replace the screw to secure the case.
WARNING!
Improperly installing the batteries will cause damage to the
batteries.
