Honeywell ADEMCO LYNX XL Series Installation And Setup Manual Download

Page: 65 / 76

Section 12. System Operation

12–5

Various Security System Trouble Displays

Alpha Display

Fixed Disp. Meaning

ALARM CANCELED

will appear if an exit or interior zone contained a fault during closing at the time
the Exit Delay ended (e.g., exit door left open), but the system was disarmed
during the Entry Delay time. The alarm sounder and keypad sound continuously,
but stop when the system is disarmed. No message will be transmitted to the
central station.

EXIT ALARM

will appear when the Exit Delay ends if an exit or interior zone contained a fault
during closing. The alarm sounder and keypad sound continuously until the
system is disarmed (or timeout occurs). An “Exit Alarm” message is sent to the
central station. Also results if an alarm from an exit or interior zone occurs within
2 minutes after the end of an Exit Delay.

CHECK

indicates that a problem exists with the displayed zone(s) and requires attention.

ALARM 1xx

1xx

indicates that communication between control and wireless

FAULT 1xx

1xx

receiver is interrupted, where “xx” is the device address. Check the

CHECK 1xx

1xx

DIP switch settings on the units.

If there are wireless sensors in the system, the Check condition may also be
caused by some change in the environment that prevents the receiver from
receiving signals from a particular sensor.

SYSTEM LO BAT

BAT

with no zone number indicates that the system's main standby battery is weak.

LO BAT

BAT

with a zone number and a once-per-minute beeping at the keypad indicates that a
low-battery condition exists in the wireless sensor displayed (zone “00” indicates a
wireless keypad). If the battery is not replaced within 30 days, a “CHECK” display
may occur.
NOTE: Some wireless sensors contain a non-replaceable long-life battery which
requires replacement of the entire unit at the end of battery life (e.g., Nos. 5802,
5802CP).

TELCO FAULT

Telephone Line Failure, indicates that a monitored telephone line (if programmed
in field *92) has been cut or disconnected. Depending on how the system was
programmed, the keypad may also produce a trouble sound, and the external
sounder may be activated. Silence by entering installer code + OFF.

Busy-Standby dl

If this remains displayed for more than 1 minute, the system is disabled.

Modem Comm

The system is in communication with the central station for change of function or
status verification.

no display

Power Failure
If there is no keypad display at all and the LEDs are unlit, operating power (AC
and battery) for the system has stopped and the system is inoperative.
If the message “AC LOSS” (Alpha display keypads) or “NO AC” (Fixed-Word
display keypads) is displayed, the keypad is operating on battery power only.
If the battery standby capacity is used up during a prolonged AC power outage,
the control's power will shut down to minimize deep discharge of the battery.

Comm. Failure

A communication failure has occurred.

Open Circuit

The keypad is not receiving signals from the control and sees an open circuit.

Long Rng Trbl

LRR communication failure.

RCVR Jam

RF jam detected.

KEYPAD LOW BAT 00 BAT

Wireless keypad low battery

Phone Okay

The dialer test has been successful (CID code 601).