– 5 –
E
E
E
Exit/Entry Delays
xit/Entry Delays
xit/Entry Delays
xit/Entry Delays
Exit Delay
•
When you arm the system, the system gives you a programmed amount of time to
leave through the designated exit door and/or certain other zones (if programmed)
without setting off an alarm.
•
A slow beeping, if programmed, will sound during the exit delay period until the last
10 seconds, which then changes to fast beeping.
•
If programmed, the keypad displays a countdown of the number of seconds of exit
delay remaining.
•
When exit delay expires, all zones become protected and cause an alarm if opened.
•
Your system may have been programmed such that exit delay remains in effect until
a final zone (e.g. exit door) has been closed for five seconds. Ask your installer.
Exit Delay
••••
Press the [
∗∗∗∗
] key
if armed in STAY mode to restart the exit delay timer.
Restart
•
This gives you time to open the entry/exit door to let someone in after arming
STAY. The system
(if programmed)
automatically re-arms when exit delay expires, which avoids having to disarm the
system and then re-arm it again.
•
When the system is armed AWAY, reopening and closing the entry/exit door before
exit delay time expires (e.g., reentering to get a forgotten item) will restart the exit
delay time.
Entry Delay
•
Gives you time to disarm the system when you re-enter through the designated
entrance door. You must disarm the system before the entry delay period ends, or an
alarm will occur.
NOTE:
When entry delay is active (ex. opening the entry door), the entry delay time
applies to
all
burglary zones in that partition.
•
See your installer for your delay times.
Partition 1
Partition 2
Common Partition
Delay 1: _______ seconds
Delay 1: _______ seconds
Delay 1: Same as Partition 1
Delay 2: _______ seconds
Delay 2: _______ seconds
Delay 2: Same as Partition 1
Exit Alarms
•
If an entry/exit door or interior zone is faulted when the exit delay ends (e.g., exit
door left open), the system sounds an alarm and starts the entry delay timer.
•
Disarming the system before entry delay ends stops the alarm sound .
•
The message "ALARM CANCELED" or "CA" is displayed on the keypad, along with
a zone number indicating the faulted zone.
•
No message is sent to the Central Monitoring Station.
•
If you do not disarm the system before the entry delay ends, and an entry/exit door
or interior zone is still open, the alarm sound continues and an "exit alarm" message
is sent to the Central Monitoring Station. The message ""EXIT ALARM" or "EA" and
the faulted zone number is displayed on the keypad.
•
To stop the alarm, the system must be disarmed (your code plus OFF); to clear the
display, enter your code plus OFF a second time.
•
An “exit alarm” also results if an entry/exit door or interior zone is faulted within
two minutes after the end of the exit delay.
To clear an exit alarm:
•
Make the open zone intact, then
•
Enter your code plus [1] OFF to clear the display.
Your system may have been programmed for this feature to minimize false alarms sent
to the Central Monitoring Station. Ask your installer if "Exit Alarm" is active in your
system. If so, check this box: [ ]
Part. 1: _____ sec
Part. 2: _____ sec
Common: Same as
Part. 1
