Step 10: Dialer Delay (*50)
Enter 0 for no dialer delay
Step 11: Changing the Master Code and User Codes
Changing the master code
Enter the Master code + 8 + 02 + New Code + the New Code again. The
keypad will beep 1 time for confirmation letting you know the code was
successfully changed.
Changing the User codes
Enter the Master/Partition Programmer Code + [8] + User New
Code NOTE: User number can be 03-49. This can be done from any
partition. The keypad will beep 1 time for confirmation letting you know the
code was successfully entered.
Press *99 to exit programming
Step 12: Time and Date
Enter your Master Code (default 1234) and # 63 then *.
Using the number pad, enter the hour, then minutes. Press 1 for PM. or 2
for AM. Then press the year and then * to save.
Adding Additional Keypads:
The following are ways to add keypads to your system. Keep in mind keypads
can be addressed 16 to 23 with no duplicates in the addresses. The keypad
should come defaulted at 31, but we will default the keypad to make sure
everything is correct.
Step 1:
Upon Power Up of the new keypad (when the main display goes blank),
Press and hold the “1” and “3” simultaneously. Then “--oo” will flash.
Step 2:
While “--oo” is flashing enter “91”, then the system will beep and “--oo”
will be displayed.
Step 3:
Press “1” and then the display will show “Ca 31”
Step 4:
Enter “00” and then the address of the keypad. For the second keypad
this would be 17, 18 for the third keypad, etc. Enter *
to save. “--00” will be
displayed and enter * again.
Your display will then show “Ad 00 17” (or the new address). The keypad will
restart on its own.
Step 5:
On your programming keypad (Main Keypad 6160, 6160RF, or 6160V),
enter into the programming mode. You will need to activate address you used
(i.e. 17) in the programming section. Use the Installation and Setup Guide for
assistance on enabling your keypad address on page 2-5.
