In order to communicate via Wi-Fi, you must configure Wi-Fi settings for the AreaRAE Plus/Pro
to match your router by using Safety Suite Device Configurator (SSDC):
1.
Connect a USB cable between the AreaRAE Plus/Pro and a PC running ProRAE Guardian.
2.
In Normal mode, press the [N/-] key until the screen shows “Enter Communication
Mode?”
3.
Press [Y/+].
4.
Start Safety Suite Device Configurator (SSDC) on the PC.
5.
Log in as Administrator. You must provide a username and password (the default
username is "administrator" and the default password is “Default123”.)
6.
When the AreaRAE Plus/Pro shows up in the list, click on the serial number.
7.
Click “Settings” from the tabs. This shows the instrument’s setup.
8.
Scroll down to “Wi-Fi.” This is where you see the current Wi-Fi parameters and can set
new ones.
9.
It is recommended that you select “Use DHCP” to dynamically set up the correct settings.
If you must use a Static IP Address (many corporate enterprises require it), check with
your I.T. administrator.
10.
Settings for “Security Mode,” “Security Key,” and “SSID” must match the settings on the
router associated with the PC or server running Safety Suite Device Configurator (SSDC).
11.
Settings for “Server IP” and “Server Port” must match those of the PC or server running
Safety Suite Device Configurator (SSDC).
12.
Once your settings are made, upload the settings to the AreaRAE Plus/Pro. Click this icon:
13.
When uploading is finished, quit Safety Suite Device Configurator (SSDC)
14.
On the AreaRAE Plus/Pro, press [Y/+] to exit Communication mode.
15.
Disconnect the USB cable.
AreaRAE
77
User Manual
Summary of Contents for AreaRAE Plus
