Appendix
BC-200 Manual
– P/N DOC-01-013
98
9
9
.
.
3
3
.
.
2
2
A
A
N
N
N
N
U
U
N
N
C
C
I
I
A
A
T
T
O
O
R
R
M
M
O
O
D
D
E
E
The LCD80 (annunciator mode) is an alphanumeric display module that acts as a remote display interface to the
BC-200. It displays pre-programmed messages of 60 characters each which are activated via a script event in the
BC-200. Up to 64 different messages are possible. A local buzzer will sound for any message annunciation or
fault (this buzzer can be disabled if required). The BC-200 can support up to 32 LCD80 units on Ring 1. Refer to
page 137 for connection and set-up details.
9.3.2.1
N
ORMAL
O
PERATION
The display will automatically show the first event point activated by the FIP. The points are displayed in the order
in which they were activated.
9.3.2.2
M
ANUAL
O
PERATION
Pressing the “NEXT” and “PREVIOUS” buttons allow the user to scroll up and down the list. When the last
message on the list is reached, the display will wrap around to the first message on the list, and vice versa.
Pressing “Mute” will silence the buzzer if active. The buzzer will resound if another event occurs and the
buzzer is enabled for that event.
The “Mute” button doubles as a “SHIFT” key. When held down, key functions are changed as follows
Shift “(VERSION)” will show the following
LCD80 mode (“Terminal” or annunciator”)
Firmware version
LCD80 address
Shift “NEXT” / “PREVIOUS” cycles through the 8 contrast modes of the LCD80 display.
(Version)
Next
Previous
Mute
3 Lines of
60 Character
Description
*Pt 1 Msg 1 of 5
Summary of Contents for BC-200
