8300-089
23
Rev 3
5.2.6.
Yaw Damper
Selectable between
0
and
1
. Setting this to
1
will engage an
installed yaw damper with the autopilot. Leave this set at
0
if no yaw
damper is installed. The YAW DAMPER setup screen is shown in
Figure 5.2.6a.
Figure 5.2.6a
5.3.
Vertical Setup
The vertical setup screen is accessed by toggling and holding the
joystick to the right for two seconds. Once in the vertical autopilot
setup menu, toggle the joystick to the right to advance the page,
toggle to the left to reverse the page, and rotate the knob to change
the value. Once vertical setup is completed, press the knob to exit.
The following sections are in the order in which you will encounter
them in the setup menu.
5.3.1.
Vertical Activity
Selectable from
0
and
24
. This setting controls the “sensitivity”
of the pitch servo. A higher setting will increase the reaction speed,
too high will cause jitteriness. A lower setting will decrease reaction
speed, too low will cause sluggishness. The VERTICAL ACT setup
screen is shown in Figure 5.3.1a
Summary of Contents for BENDIXKing xCruze 110
