MERLIN NX IP AND MST/TP VAV CONTROLLER - INSTALLATION INSTRUCTIONS
EN1Z-1076GE51 R0722
30
REGULATORY INFORMATION
FCC Regulation
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the equip
-
ment.
Canadian Regulatory Statement
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d'en compromettre le fonctionnement.
CE Statement:
The WLAN function for this device is
restricted to indoor use only when operating in the 5150 to
5350 MHz frequency range.
EMF Statement
: To maintain compliance with the RF
exposure requirement, a separation distance of 20 cm
between the device and the human should be maintained.
Déclaration d'exposition Attention: Cet émetteur doit être
installé pour fournir une distance de separation d'au moins
20 cm de toute personne.
RESTRICTIONS IN THE 5 GHZ BAND
Within the 5.15 to 5.25 GHz band, UNII devices will be
restricted to indoor operations to reduce any potential for
harmful interference to co-channel Mobile Satellite System
(MSS) operations.
RESTRICTIONS DANS LA BANDE DE 5 GHZ
Dans la bande de 5,15 à 5,25 GHz, les appareils UNII
seront restreints aux opérations intérieures pour réduire
toute possibilité d'interférence pouvant nuire aux opérations
du Système satellite mobile dans le même canal(MSS).
Professional Installation Warning
• This device must be professionally installed, this should
be noted on grantee.
• To maintain compliance, only the antenna types that
have been tested shall be used, which listed in
“Replacement Parts,” on page 2
.
• This device requires a significant technology engineering
expertise towards understanding of the tools and
relevant technology, not readily available to average
consumer. Only a person professionally trained in the
technology is competent.
This device is not directly marketed or sold to general public.
Detachable Antennae Warning (IC)
Transmitter Antenna (From Section 6.8 RSS-GEN, Issue 5,
April 2018):
— This radio transmitter [See
] has been approved by Innovation,
Science and Economic Development Canada to operate
with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in