Updating CIU 888 Site configuration
Part No.: 4417593_Rev09
Ensite Pro to CIU 888 Migration Manual
CIU 888
4 - 7
$*6
5. Click
OK
to close the dialogue box.
Depending on the entities that were changed during the update, the
CIU 888 will automatically restart after the upload. See TABLE A.3, to
view list of entities that do not require a restart after they have been
changed.
4.5 Configuring the additional configuration settings
When the implemented changes in the site configuration have been
uploaded to the CIU 888, the next step is to the configure the additional
configuration settings of the CIU 888 if required. See section 2.5 for
more information.
4.6 Updating the INI files
When the updated site configuration has been uploaded to the CIU 888
and the additional configuration settings, if required, have been
configured, the next step is to update the INI files needed for Entis Pro.
See section 4 for more information.
4.7 Restarting Entis Pro and reloading updated INI files in Entis Pro
When the INI files have been updated, the next step is to restart the
Entis Pro system connected to the CIU 888 and then reload the
updated INI files in Entis Pro. Refer to the
Configuration manual
Entis Pro version 2.70x for Windows 7
(Part No. 4416381) for more
information.
4.8 Sealing the CIU 888
If the CIU 888 features the option to be sealed, the next step is to have
it sealed by a representative of the W&M authorities or by a W&M
accredited user. Refer to the
CIU 888 Sealing Guide
(Part No. 4417595)
for more information.
NOTE: If the CIU 888 does not feature the option to be sealed, the W&M configuration
settings can either be locked or left unlocked.
4.9 Verifying the working of the CIU 888 system setup
The final step in the procedure for updating the CIU 888 system setup is
verifying if the system setup is working properly. See section 2.10 for
more information.
