CLEANING & MAINTENANCE
CLEANING THE HONEYCOMB FILTER
Turn off the unit, and unplug the power cord from wall outlet.
Rotate the unit facing the back panel, and locate the Rear Grill Removal Screws (refer page
7., No. 17). Remove both the screws with a screw driver.
Pull the rear grill panel upwards, untill it is completely removed.
Now, the Honeycomb filter can be seen. Clean the filter with clean cloth to remove all the dust
& dirt particles.
Once, the cleaning has been performed, assemble the unit back in the same fashion as
described above.
The appliance is supplied with a honeycomb cooling media filter.cooling media.
Always keep the Honeycomb media clean. Wash the filter at least twice a year or as necessary.
Draining the water tank and refilling it with fresh water atleast once a week will greatly reduce
mineral deposits in thepads and help extend the life of the honeycomb coolingmedia.
Do not run the unit in COOL mode with stale water in the tank.It is recommended to empty the
tank and refill it with freshwater, if the water has been standing inside the tank for an extended
period of time.
Cleaning frequency depends on local air and waterconditions. For example, in areas where
mineral content ofthe water is high, deposits may build up in the honeycombcooling media,
restricting air flow. In this case, it is recommended to clean the honeycomb cooling media every
twomonths.
For best results, allow the honeycomb cooling media to dryafter each use by turning off the cool
function 15 minutesbefore turning the unit off.
•
•
•
•
•
•
•
•
•
•
•
14
