USE & OPERATION (CONTINUED)
CLEANING & DRAINING THE WATER TANK
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
3
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
Refill the water tank with clean water, up to the maximum level and drain it completely.
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
When the product is not in use, store the unit in a dry place our of direct sunlight.
t
t
t
t
The appliance is supplied with a Carbon Dust Filter* &
Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling Media are
located inside the Rear Grill. See Figure 1 for instructions on
how to remove them from the unit for cleaning and
maintenance.
Do not run the unit in COOL mode with stale water in the
tank. You must empty the water tank and refill with fresh
water, especially if the tank has not been cleaned in a long
time.
The cleaning frequency for the Honeycomb media depends
on local air and water conditions. In areas where the mineral
content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the
water tank and refilling with fresh water at least once a week
will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, the media should be
removed and washed under fresh water. The media should
be cleaned every two months or sooner, depending on your
needs.
For best results allow the Honeycomb Cooling Media to dry
after each use by turning off the cool function 15 minutes
before turning the unit off.
t
t
t
t
t
FILLING WITH WATER
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
CAUTION:
Unplug the unit from the electrical power outlet before emptying or
refilling the water tank.
Open the Water Fill Door.
The Water Level Indicator is located at the back of the unit. Refill the
water tank when water level is low. Do not fill water above the "Max."
water level mark. To avoid water spillage and water droplets at the
louvers, do not fill water above the maximum indicator level. Check the
water level in the tank before running the COOL function. Make sure
that the water in the tank is above the minimum water level mark.
Running the unit in COOL mode with inadequate water may cause
pump failure.
If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE
GUIDELINES located in the separate Safety & Maintenance Guide.
Honeycomb
Cooling Media
Figure 1:
Remove all the screws from the Rear Grill of the Air
Cooler.
Carefully pull out the rear grill from the cooler.
Slide out the Carbon Dust Filter* and clean with water.
Slide the Honeycomb Media from the Honeycomb
Frame.
Replace or clean media with water and a damp cloth as
needed.
WARNING:
DO NOT operate the Air Cooler when the
Rear Grill is removed from the Air Cooler, or if there is a
loose-fitting Rear Grill. Doing so can cause serious
injury or dangerous electrical shock.
1.
2.
3.
4.
5.
Removing the Carbon Dust Filter*/ Honeycomb
Cooling Media:
*Applicable for models with Carbon Dust Filter only.
Water Fill Door
Rear Grill
Honeycomb
Frame
Carbon Dust
Filter
Screws
