3
USE & OPERATION (CONTINUED)
EN
REMOTE CONTROL
FUNCTION BUTTONS (CONTINUED)
MODE (COOL)
Press the MODE button to select COOL mode. Pressing the MODE button until COOL is illuminated on
the control panel activates evaporative cooling. The water pump will operate and you will feel the cooler
air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button until COOL is illuminated activates evaporative cooling.
Pressing the MODE button again will deactivate COOL light on the control panel, switching off
evaporative cooling.
Note:
When the cooling function is switched OFF, the unit can still function in a fan only mode (without
evaporative cooling).
NOTE:
MODE
SPEED
TIMER
SWING
Evaporative Air Cooler
ON/OFF
•
•
•
•
•
•
•
•
•
•
The remote control requires AAA (2 x 1.5V) batteries for replacement.
Open the battery compartment at the back of the remote control and insert the batteries
inside. Care must be taken to insert the batteries according to the correct polarity (+ / –)
markings shown inside the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Do not recharge the battery.
Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING:
Caution for ingestion of the small battery. Keep away from children and animals.
POWER
:
:
:
:
:
ON / OFF
Low / Medium / High / Sleep
Evaporative Cooling On / Off
Controls the motion of the louvers
Controls the Timer function for automatic off
SPEED
MODE
TIMER
SWING
