W-NXS AND CP-NXS
74-4059—01
10
Figure 8
NXS dimensions with wall mounting brackets.
When mounting, ensure that a
minimum
of 3.94" (100 mm) clearance is maintained on all sides of the NXS from other
devices and/or enclosure walls. See
page 7 for more details.
Local Console
Typically, for initial software installation and commissioning, you access the NXS
remotely
, using Niagara
AX
or
Niagara R2 software (Workbench platform connection or Admin Tool, respectively). In the case of applying Windows
updates or making Windows security setting changes, you connect remotely using the Microsoft “Remote Desktop”
software.
However, in some cases you may need a “local console” attached to the NXS, that is a keyboard, mouse, and monitor.
One example is after
, to re-enter the BIOS setup data that was lost. Note that access of
the BIOS setup of a NXS is not possible over a network connection.
Please note the following about using a local console with the NXS:
•
A USB type keyboard and mouse is required (no PS/2 type connectors).
•
A DVI-capable display is needed, or a DVI-to-VGA adapter and a VGA monitor combination that has been
tested to work with the NXS.
•
After attaching these items to the NXS, you must reboot the unit for local console operation.
11.7" (297 mm)
0.18" (4.5 mm)
3.94"
(100 mm)
0.65” (16.5 mm)
11.26" (286 mm)
10.35" (263 mm)
2.7"
(68.5 mm)
0.39" (10 mm)
