Installation Steps
Wash and Start Water Purifier
Figure 6
Step 3
：
Cut the 1/4”PE pipe into 2 sections. One section is used to connect tee joint ball valve
and filter adapter, and the other section is used to connect faucet and filter adapter, as
shown in Figure 5.
Step 4
：
Hang the whole set of the water purifier on the filter adapter screws.
：
7
Installation Instructions
1. Turn on the water inlet valve and small ball valve.
2. Open the faucet to let the water flow into the water purifier. Due to the role of carbon
particles and bubbles, the water may seem a little muddy at the start, which is normal.
3. Continuously flush new water purifier for about 10 minutes, until the water becomes
clear and no bubbles, and it can provide the drinking water.
Cold water pipe
connection nut
Sealing gasket
Tee joint
Sealing gasket
Cold water valve
Ball
Valve
Ball
Valve nut
1/4" PE
pipe
Wrapped
with PTFE
tape
Figure 5
MS composite
molecular sieve filter
cartridge (sterilization)
PP dense cotton
filter cartridge
UF membrane
filter cartridge
Plug
Ring
Nut
