The Sampler
User Manual
2
Safety Information - Read First
Use the Sampler only as specified in this manual, otherwise the protection provided by the
Sampler may be impaired.
To avoid personal injury:
• Replace the batteries as soon as the Sampler indicates a Low Battery Alarm.
• Use only batteries recommended by BW Technologies by Honeywell to prevent
damage or personal injury and maintain intrinsic safety.
• Use only approved AA alkaline or charged AA NiMH batteries properly installed in
the Sampler case. Refer to
Specifications for approved batteries
.
• To avoid personal injury or damage to the detector, use only the specified
replacement parts.
FOR SAFETY REASONS, THIS EQUIPMENT MUST BE OPERATED AND
SERVICED BY QUALIFIED PERSONNEL ONLY. READ AND UNDERSTAND THE
USER MANUAL COMPLETELY BEFORE OPERATING OR SERVICING.
•
Warning:
Substitution of components may impair Intrinsic Safety.
• This product is not a gas detector.
• Do not use the Sampler if it is damaged. Before you use the Sampler, inspect the
case. Look for cracks or missing parts.
• Do not use the detector if it is damaged. Inspect the detector before using. Look for
cracks and/or missing parts.
• If the Sampler is damaged or something is missing, contact
immediately.
• Use only recommended AA alkaline or NiMH batteries properly charged and
installed in the Sampler case. Refer to
Replacement Parts and Accessories
.
• Charge NiMH batteries using the recommended charger only. Do not use any other
charger. Failure to observe this precaution could lead to fire or explosion.
• Do not change or charge batteries in a hazardous location. Doing so will impair the
intrinsic safety of the unit and may lead to fire or explosion.
• Read and observe all instructions and precautions in the literature provided with
the charger. Failure to do so may result in fire, electric shock or other forms of
personal injury or property damage.
• Do not expose the Sampler to electrical shock and/or severe continuous
mechanical shock.
• The Sampler warranty will be void if the unit is disassembled, adjusted or serviced
by non-BW Technologies by Honeywell personnel.
• Do not immerse the Sampler in liquids.
• Confirm that the water trap is empty.
•
ec
This instrument contains batteries. Do not mix with the solid waste stream.
Spent batteries should be disposed of by a qualified recycler or hazardous
materials handler.
• Airflow can also be blocked by temporarily kinking the hose or covering the end of
the rigid tube.
• We recommend that you perform a block test once the Sampler is activated.
• If you reactivate the Sampler within a 30-minute period, it will resume normal
operation (i.e., the Sampler will not enter calibration).
• Once the Low Battery Alarm has been activated you have approximately 20
minutes before the Sampler turns off.
• To initiate a calibration, confirm the Sampler is on then press
C
and hold for
6 seconds. The Sampler beeps, then deactivates. The Sampler enters calibration
mode the next time it is activated.
• Do not tighten the rear assembly screws greater than 3.0 in-lb
