12-4
Dolphin 6000 HomeBase
Power
0
The device requires 5V, 2A DC input for communications and battery charging; the power
adapter on power cable converts voltage from power source to 5V, 2A DC. Only the
Honeywell 5 VDC, 2A power supply provided with HomeBase converts voltage correctly.
It is recommended that the HomeBase be left connected to its power source at all times, so
that it is always ready to use.
1. Connect adaptor barrel plug to DC jack on rear panel of HomeBase
2. Plug adaptor AC to indoor wall receptacle
Serial Connector
0
The following diagram shows pin diagram of serial connector of HomeBase.
NOTE:
NOTE
:
Signals referenced are for a DTE device. The HomeBase is at a right-angle to the
printed circuit board (PCB).
Figure 12-3. Serial Connector Pins
Table 12-1. Serial Connector Pins
Pin
Description
1
N/C
2
TXD
3
RXD
4
DSR
5
GND
6
N/C
7
CTS
8
RTS
9
N/C
Summary of Contents for Dolphin 6000
