Honeywell DOLPHIN 6500 User Manual Download

Page: 31 / 76

3 - 15

• Excessive discharge damages a battery. Recharge the battery when your terminal indicates low battery

power.

• If you observe that the Honeywell battery supplied is physically damaged in some way, send it to

Honeywell International Inc. or an authorized service center for inspection. Refer to the

Product Service

and Repair

(page 10-1) section of this guide.

• Although your battery can be recharged many times, it will eventually be depleted. Replace it after the

battery is unable to hold an adequate charge.

• If you are not sure the battery or charger is working properly, send it to Honeywell International or an

authorized service center for inspection.

Internal Backup Battery

Located inside the terminal, the backup battery is a 3.7V Lithium Polymer battery.

The internal backup battery prevents the terminal from being reset when you remove the main battery
pack. This backup battery retains RAM data and allows the real-time clock to remain operational for at
least 30 minutes. If the terminal is left without the main battery pack for more than 30 minutes, the internal
backup battery discharges and needs to be recharged to function according to specifications.

Note: Even if the internal backup battery fails, data and programs stored in Flash memory (\\Honeywell\AutoInstall)

or on an optional SD card are not lost. However, the terminal automatically cold boots when you install a fully
charged battery pack and you will need to reset the real-time clock.

Charging

The internal backup battery charges off the main battery pack and requires 2 hours charge time to backup
RAM data for 30 minutes. You can begin using the Dolphin terminal after charging the main battery for an
average of 5 1/2 hours for a fully depleted battery; however, the internal backup battery will continue to
charge off the main battery. It takes less time to charge the main battery if the battery has some charge.

To ensure that the internal backup battery functions properly, maintain a consistent power supply for the
first eight hours of terminal operation. This power supply can be external power (using a charging
peripheral) or an installed, charged battery pack or a combination of both.

Charging Guidelines

Follow these guidelines to maximize the life of the Dolphin 6500’s internal backup battery under normal
usage conditions:

• Keep a charged Li-Ion battery pack in the Dolphin terminal.
• Keep the Dolphin terminal connected to a power source when the terminal is not in use.

Resetting the Terminal

Soft Reset:

Using the stylus, press the

Reset

button. The screen turns white and the decode/scan LED flashes

blue for approximately 10 seconds.

Hard Reset:

28-key: Press and hold the

Power

button and then using the stylus, press the

Reset

button.

52-key: Press and hold the

Blue

and

(

Power

) buttons and then using the stylus, press the

Reset

button.

The screen turns white and the decode/scan LED flashes blue for approximately 18 seconds.

Soft Reset (Warm Boot)

A soft reset re-boots the terminal without losing RAM data, terminates all running applications, reloads
the OS, and launches Autoinstall, which installs any CAB or REG files in the

\\Honeywell\AutoInstall

folder.