2
Routine operator inspections should occur to check
for possible terminal damage and to ensure the
presence of the I/O cover before using the terminal in
areas known to be hazardous.
The following warnings apply to
99EX
XXX-XXXXXXX
I
Equipment for Use in Potentially
for agency approval
by country).
Note: Replace only with battery pack model 99EX-BTSC (PN 99EX-
BTSC-2) or 99EX-BTEC (PN 99EX-BTEC-2), manufactured for
Honeywell International Inc.
CAUTION
- DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH THE
SAME OR EQUIVALENT TYPE.
ATTENTION
- RISQUE D'EXPLOSION SI LA PILE N'EST PAS
REMPLACEÉ CORRECTEMENT. REMPLACIER
UNIQUEMENT PAR UNE PILE DE TYPE IDENTIQUE OU
ÉQUIVALENT.
WARNING
- EXPLOSION HAZARD - BATTERIES MUST
ONLY BE CHANGED IN AN AREA KNOWN TO BE
NON-HAZARDOUS.
AVERTISSEMENT
- RISQUE D'EXPLOSION-AFIN D'EVITER
TOUT RISQUE D'EXPLOSION, S'ASSURER QUE
L'EMPLACEMENT EST DESIGNE NON DANGEREUX AVANT
DE CHANGER LA BATTER I E.
Warning:
Explosion hazard. Do not disconnect battery unless
the area is known to be free of ignitable concentrations.
Warning:
Explosion Hazard. Charge the battery only in an area
known to be non-hazardous.
Warning:
Explosion Hazard. Do not replace components unless
power has been switched off or the area is known to be non-
hazardous.
Warning:
Substitution of any components may impair suitability.
!
!
!
!
!
!
