Loading Arms (3)
5 - 3
Model 1010 Application Pack CB
Part No.: 4418024 - Rev. 1
Programming Manual
Select one of the following options:
L & L/min* (Litre, Litre/min, °C, kPa)
m
3
& m
3
/h (metre³, metre³/hour, °C, kPa)
kg & kg/min (kilogram, kilogram/ minute)
t & t/hour (tonne & tonne/hour)
g & g/min (gram, gram/minute)
Units
Selects the US units that are displayed for the particular arm.
Constraints:
Only if Units under General Setup (21) = US Units.
Select one of the following options:
Gal & Gal/min* (Gallon, Gallon/min, °F, psi)
lb & lb/min (pound, pound/ minute)
Preset Prompt Arm n
Allows the operator to select between a Mass or Volume based
preset when mass has been selected for the arm units.
Constraints:
Only available if the selected arm is single product
straight loading arm and the selected unit is mass unit.
Select one of the following options:
Mass *
Volume
Preset Unit Arm 1
Displays the unit displayed in preset prompt.
Constraints:
Only available if the selected arm is single product
straight loading arm and the selected unit is mass unit
and the preset unit is selected as volume unit.
Maximum Preset
Sets a maximum preset for the associated arm.
Constraints:
Only available when you use the Weights and Measures
switch on the instrument to enter programming mode.
NOTE: To limit the probability of a major overfill, set the maximum preset close to
the volume of the largest compartment or tank to be filled.
Enter a value in the following range:
0 to 9999999 (9999999*)
5.2.4 Flow Control
Arm Slow Flow
The desired flow rate when slow flow is required at the start and end of
a batch.
Enter a value in the following range:
0 to 800 (300*)
