Additive Lines (6)
8 - 2
Model 1010 Application Pack CB
Part No.: 4418024 - Rev. 1
Programming Manual
Constraints:
Additive Inject = Pulse Output
Enter a value in the following range:
0.5 to 10 (2.0*)
No of Injection Points
Sets the total number of Injector Lines available
Constraints:
Only for Additive Inject = EFT Mini-Pak
Enter a value in the following range:
1 to 18 (1*)
8.4 Additive Line Setup (622)
8.4.1 Description
Configures the operating parameters of the selected additive line of the
EFT Mini-Pak.
8.4.2 EFT Mini-Pak
Injector No n
Arm Number n
Assigns an injector number (n) to an arm number. If you do not wish to
assign an additive injector, select NONE.
Changing an injector load arm will erase the arm's recipes.
Constraints:
Only for Additive Inject = EFT Mini-Pak.
Enter a value in the following range:
0 to 4 (1*)
Injector No n
Address
Sets the Injector programming address for injector line number n.
Constraints:
Only for Additive Inject = EFT Mini-Pak.
Enter a value in the following range:
1 to 997 (1*)
Edit Additive n
Code
Use to enter a 9 character alphanumeric description of the additive
being used on injector line n.
Constraints:
Only for Additive Inject = EFT Mini-Pak.
Select one of the following options:
9 Character alphanumeric
8.5 Internal additive Lines (61)
The Internal Additive Lines menu allows configuration of each internal
additive. The number of injection points available depends upon the
sales code.
NOTE:
Not available for sales codes G, H and J.
