To bind the Wireless Relay Box (BDR91)
1
On the Wireless Relay Box, press and hold the
button for 15 seconds (until the red LED blinks
rapidly) to clear any previous binding data
2
Press and hold the button again for 5 seconds
(until the red LED blinks slowly)
3
On the evohome Controller press the green bind button
4
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
You may need to refer to
the wiring diagrams in the
Appendix
!
HOlD
15 SEC
HOlD
5 SEC
1
2
17
evohome
Installation Guide
Summary of Contents for Evohome
Page 1: ...evohome Installation Guide ...
Page 14: ...12 Step 2 Set up your Central Controller ...
Page 38: ...36 Step 4 System test ...
