38
evotouch
Binding room setpoint
4.7.2
Follow the guided or expert configuration until the
f
following screen appears.
Press and hold the installation button (1) at the underfloor
f
heating controller again for approx. 2 seconds.
The LED of zone 1 (2) flashes green.
1
3
2
Position the
f
evotouch controller as close as possible
to the underfloor heating controller.
Press the BIND button on the
f
evotouch controller
to send the bind signal to the underfloor heating
controller.
The LED of zone 1 (2) lights continuously green.
Binding of further zones
i
In order to assign further zones press the installation button again until the LED of the desired zone flashes red and
then repeat the binding procedure.
Summary of Contents for EVOTOUCH CONTROLLER
Page 1: ...1 Application Manual ...
Page 46: ...46 evotouch ...
Page 47: ...Application Manual 47 ...