To change to the default level from a higher level
1. In the Command Zone type
bye
and press ENTER.
Understanding security levels
Your security level determines which tasks you are permitted to perform. Note, however, that
even if you are allowed to perform a particular task you may be prevented from performing it
in certain circumstances.
If you attempt to perform a task that requires a higher security level, the following message
appears in the Message Zone:
Higher Security Level Required
Your security level appears at the right of the Status Bar. The levels are, from lowest to
highest:
View Only
,
Ack Only
,
OPER
,
SUPV
,
ENGR
and
mngr
.
Changing Station's setup file
Station automatically uses
default.stn
unless you select another setup file. Use this procedure
if you want to use a setup file other than
default.stn
.
To select another Station setup file
1. Choose
StationConnect
.
The
Connect
dialog box opens.
2. Select the appropriate configuration file from the
Recent Connections
tab or the
Other
Connections
tab.
The Recent Connections tab contains a list of setup files (.stn) most recently used. The
Other Connections tab lists all your setup files. If your setup file is not listed, click the
Browse
button to navigate the required setup file.
3. Click
Connect
.
Changing the Asset Profile of a Station or a Console
Depending on a system’s configuration it may be possible to change the scope of
responsibility (SOR) of a Flex Station or a Console Station by assigning a different asset
profile. This functionality can be used to enable an operator to, for example, temporarily
change their Station’s SOR to assist another operator during a period of high alarm activity.
Understanding the basics
Honeywell 2017
23
