icon stops flashing.
2. Right-click the message again and choose
Confirm Message
.
The
Electronic Signature
dialog box opens.
3. Click the
Primary signature
tab and type your user name if required.
4. If required, select a predefined reason from the
Reasons
list.
5. Type your password if required.
6. Type your domain if required.
7. Type any additional information under
Comments
.
8. Click
Sign
.
Your signature is locked in and cannot be changed.
9. Click the
Secondary signature
tab.
Attention:
The following steps must be performed by the second signer.
10. Check that you have the security level required perform this task—the minimum secur-
ity level is shown in the
Secondary signature
tab.
11. Type your user name and password (and domain if required).
12. If required, type any additional comments under
Comments
.
13. Click
OK
.
Confirmation is sent to the controller, and an event is generated recording your names
as the signers.
Depending on how your system is configured, the message:
l
Is removed from the Message Summary when it is acknowledged, or
l
Remains on the Message Summary until it is manually cleared. (To manually
clear a message, right-click the message and choose
Clear Message
.)
Clearing messages
If your system has been configured to require operators to manually clear messages, messages
will remain in the Message Summary until they are cleared even if they have been
acknowledged (or acknowledged and confirmed).
Responding to messages
Honeywell 2017
187
