Using displays
Station's displays are, in effect, a set of control panels through which you monitor and control
your system. The following topics describe how you call them up and use them.
Calling up a display
Typically the operator displays are listed on the
View
menu, however the custom displays for
your site may be listed under a custom menu.
To call up a display
1. Click the
View
menu.
A list of displays appears. (The list also includes commands).
2. Click the item you want to view, for example
Alarms
.
Tip:
If you know the name or number of a display, you can call it up from the
Command Zone. For example, to call up the numbered display
145
, type
pag 145
and press
ENTER
. To call up a named display
primary
, type
primary
and press
ENTER
.
Using tabbed displays
If tabbed displays are enabled at your site, you can call up displays in individual tabs within a
Station window. Each time you call up a display you can choose to open it in an existing tab
or in a new tab.
About tabbed displays
If tabbed displays are enabled in your system, you can view more than one display at a time
in separate tabs .
Attention:
Tabbed displays are not supported within eServer.
An example of tabbed displays in single window Station
Using displays
Honeywell 2017
43
