F118 IN-CEILING MEDIA AIR CLEANER
7
68-0209-2 Revised 11-07
Fig. 7. Installing CPZ Modules.
Install Grille
When installed, the grille can travel down a radius of
approximately 4 ft. (1m). It should be able to swing freely
without office furniture or machinery obstruction. If unlatching
the grille is a problem, replace the hinge hardware with the
spring-loaded plungers so the grille opens in the opposite
direction. See Fig. 8.
1.
Select the preferred installation position for the grille.
2.
Reinstall the lock nuts and bolts in the hinge corners.
3.
Reinstall the spring-loaded plungers and hardware at
the opposite end of the cabinet.
4.
Close and latch the grille.
When installed and latched, the grille protrudes about one
inch below the surface of the drop ceiling. Proper operation of
the air cleaner requires that it be level.
Fig. 8. Installing grille.
F118 CABINET
TIP CPZ™ SORBENT FILTER
MODULE SLIGHTLY TO
INSERT INTO F118 CABINET
M14418
SET CORNER OF FILTER
MODULE ON INNER TAB
UPPER EDGE OF
FILTER MODULE
WILL REST ON
F118 CABINET
1
2
M14419
SUPPORT
RODS (2)
FILTERS
CPZ SORBENT
MODULE (2)
3-SPEED SWITCH
VENTS
OPEN GRILLE
HANGS 4 FT. (1 M)
FROM CEILING
SPRING-LOADED PLUNGER
(PULL APART THEN
TOWARD YOU TO OPEN)
CABINET CONCEALED
ABOVE DROP CEILING
HINGE
HINGE CAN BE PLACED AT EITHER END.
1
1
CLOSED GRILLE
(1 INCH IS VISIBLE)
