3
Can I control the direction of the air leaving the air
cleaner?
Adjust the direction of the clean air using the directional
louvres
.
HOW DO I CLEAN THE ELECTROSTATIC CELL AND PREFILTER?
{It is essential to wash the cell and prefilter regularly to maintain efficiency}
1. Isolate the device from the mains supply.
2. Remove the access cover
by pressing firmly on
both sides.
3. Slide out the cell
and prefilter
.
NOTE: CEILING MOUNTED MODELS
To remove cell and prefilter for washing, carefully release
cell retention clip
while supporting the cell and
prefilter with your other hand to prevent them from falling.
WASHING THE CELL
Dilute the detergent according to manufacturers instruc-
tions and soak the cell in the solution agitating frequently
until free from dirt.
Be careful!
Wear rubber gloves when washing the cell taking care to
avoid damaging the cell and injuring yourself.
CAUTION!
•
RESPECT YOUR ENVIRONMENT! ONLY USE DETERGENT LOW IN PHOSPHATES!
•
DO NOT USE ACID BASED DETERGENTS AS THESE WILL CORRODE THE CELL.
•
DO NOT USE ADDITIVE INTENDED TO GIVE SPARKLE TO GLASSWARE IN DOMESTIC
DISHWASHERS. THIS WILL REDUCE THE EFFICIENCY OF THE CELL.
What should I do if the handset doesn’t work?
To switch the air cleaner on use the switch
under the
access cover
. Press firmly on both sides of the
access cover and remove to reveal switch. Replace
cover again and the air cleaner will run at selected speed.
Remember to switch back to REMOTE position
before trying to use the handset again.
Summary of Contents for F90C
Page 41: ...42 ...
