FA-300 Alarm Bar User’s Guide
6
4 Installation
4.1 Mounting the FA-300 Alarm Bar
The FA-300 Alarm Bar is designed to be wall-mounted
and has four holes for anchoring the FA-300 Alarm Bar,
using screws or bolts.
Before mounting the FA-300 Alarm Bar, make sure that its
cord can reach the controller that it will be electrically
connected to.
Make sure that there is approximately 12" (30 cm) of
clearance on all sides of the FA-300 Alarm Bar so that the
siren’s sound is not attenuated and to ensure clear view of
the four visible alarm lights.
Follow these steps:
1. Locate the FA-300 Alarm Bar on a wall or other flat
surface and mark the four holes’ locations.
2. Remove the FA-300 Alarm Bar.
3. Drill the four holes.
4. Hold the FA-300 Alarm Bar firmly against the wall and
insert and tighten the screws.
The FA-300 Alarm Bar is now ready to be connected to
the controller.
