GENESIS DM CLINICAL GUIDE
Patient Training
P.4510EN.01
12/5/2007
48
Cleaning the NIBP cuffs
1.
Remove bladders from each cuff.
2.
Using a mild disinfectant/detergent and warm water, wash cuffs by hand or in a washing machine.
3.
Hang cuffs to dry. DO NOT dry cuffs in a dryer.
4.
When cuffs are dry, replace the bladders.
To obtain accurate blood pressure readings, you
must
insert the correct bladder size for the cuff.
Inspection
Any time you visit a patient, it is a good idea to inspect the Genesis DM monitor and accessories. You
should check the following:
•
Power cord is not frayed or connected to unauthorized equipment.
•
Cables are properly attached and in good condition.
•
All accessories are securely attached.
•
Monitor is not standing in or near water.
•
Monitor has not been moved to an unsuitable location.
If there is a frayed power cord or if the unit is attached to unauthorized equipment, unplug the unit and
notify Customer Service.
If a monitor has been dropped or damaged, call Customer Service. Qualified service personnel
must
inspect any dropped or damaged units before they are assigned for use.
Calibration verification
Honeywell HomMed recommends that you establish and routinely follow a calibration schedule for all
measurement devices. If equipment appears to be out of calibration, you may choose to verify
calibration using the instructions in this section, or you may contact Customer Service. Honeywell
HomMed’s repair policy is as follows:
If the item is under warranty
and
the repair is covered under the warranty, there is no charge for the
repair service.
If the item is no longer under warranty,
or
if the repair is not covered in the warranty, we will charge a
fee for the repair.
For additional warranty information, please refer to your contract.
This section provides instructions for calibration verification for Honeywell HomMed equipment. For
peripheral medical devices, follow the manufacturer’s service and maintenance instructions.
Summary of Contents for GENESIS DM
Page 2: ......
