7
Duress code
Use a duress code if you are forced to disarm your security
system under duress. Your duress code is obtained by adding 1
to the last digit of your code (e.g. 1234 => 1235, 6789 => 6780).
The system will disarm as normal but a silent alert signal is
transmitted to your alarm company (depending on the
configuration).
Switch on/off receivers
Note:
This function is optional, and can be set at installation.
It is possible to switch on/off receivers (such as smart plugs) from
the keypad.
To switch a receiver on/off:
1. Press the
key
to switch the selected receiver on or the
key to switch the selected receiver off.
2. Select the desired receiver by pressing a key corresponding to
the receiver number 0 to 9 (0 corresponds to receiver number
10).
A high beep is played if the receiver is driven successfully;
otherwise a low beep is played.
Remote Maintenance (optional)
Note:
This function is optional and depends on the panel
configuration.
Press the
+
keys simultaneously to activate the remote
maintenance function as configured by your installer. Ask your
installer for more information on this function.
