Honeywell GX-48 Installation And Setup Manual Download

Page: 104 / 208

GX-Series Control Panel Installation and Setup Guide

6-58

03 Intruder

The

Intruder

function is inactive when the system is unset (disarmed). When the system is set (armed),

activation of an

Intruder

zone causes a full alarm activation that requires to be reset with a code

authorized for

System Reset

– refer to option

51.6 = PARAMETERS.System Reset

and option

51.55.3 =

PARAMETERS.Confirm.Reduce Reset.

All zones are programmed as

Intruder

by default; this includes the zones on RIOs that are added to the

system at a later date.

04 24 Hours

The

24 Hours

zone function is continuously operational. In the unset (disarmed) state, activation of the zone

function generates a local alarm condition (the

Intruder

outputs are not activated). If the zone is activated

while the system is set, the

24 Hours

function operates the same as an

Intruder

function and results in a

full alarm condition. The

24 Hours

zone function requires a system reset following an activation in both the

set (armed) and unset (disarmed) conditions.

05 Security

The operation of the

Security

zone function is identical to the

24 Hours

zone function, except a

Security

zone activation in the unset (disarmed) state generates a local alarm (

Horn

outputs activated) that does not

require a system reset; any valid code (type 2 or above) cancels the alarm and resets the system. An
activation in the set (armed) state generates a full alarm that requires a system reset. The activation (

) and

restoration (–) of

Security

zones is recorded in the event log.

06 Dual (Double Knock) {Not for UL installations}

The operation of the

Dual

(Double Knock) function is identical to the

Intruder

function, with the exception

that an alarm condition is activated only when there have been two activations from any

Dual

zones

(assigned to the same group) within a 20 minute period while the system is set.

07 Entry

This function initiates the unsetting (disarming) procedure in the same way as a

Final

zone. However,

during the setting (arming) routine an

Entry

zone operates as an

Exit

zone type. This function is normally

used in conjunction with a

Push Set

zone, which acts as the exit terminator for the setting (arming)

procedure.

Pressing the

key when programming an

Entry

zone doubles the entry time of the group.

Opening an

Entry

zone during the exit time is reported on the keypad as an open zone; the

Entry/Exit

Horns

bleep rapidly to indicate that the zone is open.

08 Push Set {Not for UL installations}

This zone function is used to terminate the setting (arming) routine. The system sets when the

Push Set

zone, usually a push button, is activated. The

Entry/Exit Horn

stops immediately the button is pressed;

the system sets after four seconds, allowing the doors to settle to the closed state. The

Push Set

zone

remains inactive until the next setting (arming) routine.

NOTE: The Push Set zone can be either 1k

Ω

going to 2k

Ω

or 2k

Ω

to 1k

Ω

- refer to Installation Manual (II1-

0033), System Architecture for wiring details. The first time that the Push Set is used to terminate the
setting/arming, the button will require to be pressed twice; the first press identifies the normal status of
the button to the system.

Activating a

Push Set

zone during the exit time is not reported on the keypad as an open zone; the

Entry/

Exit Horns

bleep rapidly to indicate that the zone is open.

NOTE: The termination feature of a Final zone can be extended to terminate the setting (arming) of multiple

groups by pressing the * key when assigning a group to the zone. Refer to the Star * Group Function.