Honeywell GX-48 Installation And Setup Manual Download

Page: 169 / 208

GX-Series Control Panel Installation and Setup Guide

6-123

Use the

A> or <B

key to select the required group (

A1–D8

). When the end of a block is reached, the next

block of eight groups is displayed; use keys

1–8

to assign the relevant group in the current block to the zone;

press the

ent

key to accept the selection.

Account Group Autosetting

The GX-Series allows Account Group autosetting (autoarming). This means that several groups can be
bound together into one account group and, instead of a sending a normal CA event, the panel sends a CL
event.

Refer to menu option

56.1.2.2.2 = Communications.Internal Telecoms.Format.SIA.Group

Settings.Account No.

There are five stages to programming the

Autoset

function:

1. Autoset Status

0 = Off

(default)

1 = On
2 = Monitor

- if selected, the setting (arming) and unsetting (disarming) of the group is monitored:

•

if not set (armed) manually before the

time, then the

Set Late

output is activated

•

if unset (disarmed) before the

Off

time, then the

Unset (disarmed) Early

output is activated.

2. Prewarning

1 = Period
0 – 50 minutes

(default 30 minutes):

2 = Audible

(this can be turned ON or OFF)

This option determines the warning period given to users prior to the system autosetting. Outputs
programmed as

Prewarning

activate during the prewarning period. The output normally emits a

constant tone, however if an extension is not possible, then a pulsed tone is emitted and prewarn
activates at the Autoset time. At the end of the prewarning period, the system begins the timed setting
(arming) procedure.

NOTE: Pressing the esc key at any time during the prewarning resets and restarts the prewarning countdown.

If more than one group is in the prewarning period, each group can be viewed by pressing * and > or *
and <.

3. Extension

0 – 400 minutes

(default 30 minutes):

An autoset

Extension

can be assigned to each group on the system - programmed with different values

per group. Entering a user code during the

Prewarning

delays the autosetting/arming by the period

assigned to the

Extension

NOTE: The Late Working option (refer to option 45 = TIMERS) authorizes an Extension in advance of the

Prewarning period.

Late Set

appears if the system is not set (armed) after prewarn time plus 300 seconds (longest possible

exit delay) An

Extension

cannot be granted once the timed setting (arming) procedure begins.

4. Force Set

0 = Off (default)
1 = On

As a factory preset, any zone that is open at the start of the setting (arming) procedure - except

Final

Exit

Entry

, or

Push Set

, (or

Secure Final

Part Final

when acting as a

Final

) - is omitted by the

autoset routine whether or not it is omittable. If one of the above listed zones is open and is non-
omittable, on expiry of the time programmed in the

Fail-to-Set

parameter the

Fail-to-Set

outputs are

activated along with a full alarm.

5. Weekly Schedule

This option assigns a programmed weekly schedule for each group when the selected group is automatically
switched

(Autoset) and

Off

(Autounset).

When the keyswitch is activated twice during the exit time of an autoset, the autoset is temporarily
cancelled for a few seconds, then it restarts the exit time causing the panel to reset.