Honeywell HBW-00-TE-HA-9X, User Manual

Honeywell  Industrial  Wireless                                                                                                                                                                                                                                           High  Gain  Omni-Directional  Antenna 

Warning:

 Always use caution when installing this antenna. You can be 

seriously injured if this antenna comes near or in contact with a power line. 
Follow all local and national electrical code requirements when installing the 
Base Radio with the high gain antenna. 

[1] 

Select the locations for the high gain antenna, the lightning arrestor and 
Base Radio. 

Any Base Radio with an Omni Directional antenna is for 
ordinary locations only.

It is recommended that the lightning arrestor be mounted in close 
proximity to the building egress. The lightning arrestor should be 
mounted indoors unless you have the weatherproof enclosure. 

The location for the high gain antenna should be selected based on 

optimal positioning for RF communications with the field units and allow 
for sufficient length of coaxial cable to reach the building egress. 

The Base Radio should be installed in a location where there is sufficient 

coaxial cable available to reach the building egress. 

[2] 

Position the antenna so that the gold sleeve clears any obstructions. 

[3] 

Mount the antenna using the 
2 mounting brackets. One 
clamp must be placed at the 
center of the gold sleeve, the 
other at any point below. 

[4] 

Connect the Base Radio coaxial cable to the lightning arrestor and tighten 
by hand. 

[5] 

Attach the ground wire to a suitable earth ground connection.  Keep this 
wire as short as possible. Make sure this connection conforms to 
electrical code requirements. 

[6] 

Connect the lightning arrestor coaxial cable to the antenna and hand 
tighten. 

[7] 

Install a drip loop in the cable to insure proper drainage. 

[8] 

Wrap the antenna connection with the supplied waterproofing material.

Note: Do not cover the drain holes on the bottom of the antenna as they 
provide drainage for moisture. 

[9] Finished. 

Rev. 4 

0806  

User Manual 

5