Set Up and Calibration Procedures
CAL POSOUT Group
Revision 7
HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
63
7/08
CAL POSOUT Group
The CAL POSOUT group is used to verify that the position sensor is operating and adjusted properly. This
group allows the local display to indicate the output voltage of the position sensor. This display is used
when verifying the POS sensor is operating and that it is properly calibrated. Table 23 shows the selections
available for the CAL POSOUT group.
Table 23 CAL POSOUT Group Parameters
Actuator Lower
Display
Prompt
Selections or
Range of Setting
Parameter Definition/PDA HercuLink Prompt
CALPOS
n.nnn
POSITION SENSOR OUTPUT
—
Read Only.
Displays the
output voltage of the position sensor
To access the display…
Press
Result
SETUP
until you see
Upper Display
=
CAL
Lower Display
=
POSOUT
FUNCTION
Upper Display
=
DIS
Lower Display
=
CALPOS
or
key
Upper Display
=
BEGN
Lower Display
=
CALPOS
FUNCTION
Upper Display
=
n.nnn
(sensor output in volts)
Lower Display
=
POSOUT