50403/SA2/1305
13
HERMetic Sampler A2
6.2 Operating the ZONE SAMPLING BOTTLE
ND
TS
DESCRIPTION
30329
10380
Zone Bottle 0,43 l. Viton assy
1.
Remove the 2” cover from the valve.
2.
Install the sampler on top of the valve.
3. Open the valve.
4.
Lower the bottle at a minimum speed of 0,5 m/sec.
If the lowering speed is too low the liquid will not flow through the bottle. The resistance of
the ball to flowing has to be higher than its weight to keep open the bottom valve of the
bottle.
5.
Stop the lowering at the level where the sample is to be taken.
6.
Lift the bottle back into the sampler housing.
7.
Close the valve.
8.
Remove the cover of the sampler together with the bottle and pour its content into a
laboratory bottle with a minimum 2” neck diameter.
9.
Reassemble the bottle and cover to the sampler.
10. Remove the sampler from the valve.
11.
Reinstall the 2” cover on top of the valve.
12. Clean the equipment after use and check it for proper functioning.
