68
We can also adjust the items order by click the button
and
.
After all the items were done, click the button
will configure the edited
output sequence into the reader.
And this sequence will take effect immediately.
Output Sequence Configuration Panel
To enable the output sequence matching, we should also configure some following
settings.
Output Mode
When the output sequence is
Off
, the bar code data is output to the host as the
reader decodes it.
When an output sequence is
Required
, all output data must conform to an edited
sequence or the reader will not transmit the output data to the host device.
When it’s
On/Not Required
, the reader will attempt to get output data to conform to
an edited sequence but, if it cannot, the reader transmits all output data to the host
device as is.
When it’s
No Rule
, the output data will not conform to the edited sequence, it will
buffer all the decoded data and output them when the timeout occurs or the data
numbers meet the scan count. The scan count can also be set.
Transmit Partial Sequence
If an output sequence operation is terminated before all your output sequence criteria
are met, the bar code data acquired to that point is a “partial sequence”.
Disable this function will discard partial sequences when the output sequence
operation is terminated before completion.
Enable this function will transmit the partial sequences. (Any fields in the sequence
where no data match occurred will be skipped in the output.)
Partial Prefix
This setting is to add prefix to partial output sequences.
Partial Suffix
This setting is to add suffix to partial output sequences.
Summary of Contents for HF800 Series
