54
HH1800 User Guide
•
The maximum size of a prefix or suffix configuration is 200 characters, which includes
header information.
Add a Prefix or Suffix:
Step 1. Scan the
Add Prefix
or
Add Suffix
symbol (
Step 2. Determine the 2 digit hex value from the
for the symbology to which you want to apply the prefix or suffix. For example, for
Code 128, Code ID is “j” and Hex ID is
“6A”.
Step 3. Scan the 2 hex digits from the
, beginning on page 211 , or scan
9, 9
for all symbologies.
To add the Code I.D., scan
5, C, 8, 0
.
To add the AIM I.D., scan
5, C, 8, 1
.
To add the serial number, scan
5, C, 8, 8
.
To add a backslash (\), scan
5, C, 5, C
.
Note:
When adding a backslash (\), you must scan 5C twice
–
once to create the leading backslash
and then to create the backslash itself.
Step 4. Repeat Steps 2 and 3 for every prefix or suffix character.
Step 5. Scan
Save
to exit and save, or scan
Discard
to exit without saving.
Repeat the steps above to add a prefix or suffix for another symbology.
Example: Add a Tab Suffix to All Symbologies
Step 1. Scan
Add Suffix
.
Step 2. Scan
9, 9
from the
, beginning on page 211 to apply this suffix to
all symbologies.
Step 3. Scan
0, 9
from the
, beginning on page 211. This corresponds
with the hex value for a horizontal tab, shown in the
Step 4. Scan
Save
, or scan
Discard
to exit without saving.
Clear One or All Prefixes or Suffixes
You can clear a single prefix or suffix, or clear all prefixes/suffixes for a symbology. If you have
been entering prefixes and suffixes for single symbologies, you can use
Clear One Prefix
(
Suffix
) to delete a specific character from a symbology. When you
Clear All Prefixes
