HH1800 User Guide
41
Low Priority Symbology
To specify the low priority symbology, scan the
Low Priority Symbology
barcode below. On
on page 200, find the symbology you want to set as low priority. Locate
the Hex value for that symbology and scan the 2 digit hex value from the
If you want to set additional low priority symbologies, scan
FF
, then scan the 2 digit hex value
from the
beginning on page 211, for the next symbology. You can
program up to 5 low priority symbologies. Scan
Save
to save your selection.
Default = None
.
Low Priority Symbology
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority
symbologies, you must set the time-out period. This is the period of time the scanner will
search for a high priority barcode after a low priority barcode has been encountered. Scan the
barcode below, then set the delay (from 1-3,000 milliseconds) by scanning digits from the
beginning on page 211, then
Save
.
Default = 500 ms.
Preferred Symbology Time-out
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default values.
Preferred Symbology Default
