HH490 User Guide
41
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology barcode
below. On the
on page 200, find the symbology you want to set
as low priority. Locate the Hex value for that symbology and scan the 2 digit hex
value from the
If you want to set additional low priority symbologies, scan FF, then scan the 2
digit hex value from the
beginning on page 211, for the next
symbology. You can program up to 5 low priority symbologies. Scan Save to save
your selection.
Default = None
.
Low Priority Symbology
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low
priority symbologies, you must set the time-out period. This is the period of time
the scanner will search for a high priority barcode after a low priority barcode has
been encountered. Scan the barcode below, then set the delay (from 1-3,000
milliseconds) by scanning digits from the
page 211, then Save.
Default = 500 ms.
Preferred Symbology Time-out
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default
values.
Preferred Symbology Default
