It is important that the installation instructions below are followed for successful installation of this
portable air conditioner. Please call Customer Support if you have any difficulties or queries regarding
these installation procedures.
1.
2. Adjust the window bracket as per width or
height of your window and insert the plastic
pin
There is a hole where the Plastic Hose will be
inserted later. Make sure this hole is not
blocked.
3. Connect the plastic hose to the hose
connector on back of the unit.
4.
Ensure that all connections are tight and
installed properly.
Note:
After setting the window bracket to the size of your
window, please remove it from the window and
follow the instructions below.
INSTALLATION
1.
2.
3.
4.
5.
Window Bracket Kit.............................
Window Bracket Panel Adapter...........
Plastic Pin............................................
Hose Connector..................................
Plastic Hose........................................
Installation Kit:
Installation Steps:
1 Set
1 Piece
1 Piece
1 Piece
5. Connect the window bracket to the window.
6. The Portable Air Conditioner is now ready to use.
EN
3
Plastic Hose:
Dia.
Length:
1
x 2
6. Drain Tube (refer to Continuous
Draining for Dehumidifier Mode)..........
2 Half Pieces
1 Piece
Adjust the window bracket as per width or
height of your window and insert the plastic
pin to fix at the desired position.
Plastic Pin
Hole for Window Bracket
Panel Adapter & Plastic Hose
Slide-in the hose connector downwards
until it is locked in place.
5.9" (15cm)
10.6" to 59" (27cm to 150cm)
Connect the window bracket to the window
bracket panel adapter.
1 Piece
1 Piece
26.6", 36.2" to 52"
(67.5cm, 92cm to 132cm)
Install the plastic hose with window bracket adapter and hose connector on both sides. Ensure
proper fit on both ends.
2
5
x 1
x 1
3
x 1
6
x 1
x 1
x 1
4
