P4607EN.01
12/2010
6
After connecting the Bluetooth Adapter and Adapter Cable to the DM Monitor and making sure that the slide switch is toward the
connector end, power ON the DM Monitor. When prompted, enter the Setup Wizard by pressing YES.
Connecting One Wireless Scale:
The monitor will direct the user to place the Scale in its final position and the display will indicate this, along with the request to press (Yes)
to continue.
Power up the scale (using either batteries or the AC power adapter supplied), and place the scale in a position convenient for the patient.
Press YES to allow the monitor to detect the scale.
NOTE:
The scale should be less than 30 feet (10 meters) from the monitor for signal acquisition. The reason that the scale should be less
than 30 feet (10 meters) from the monitor is that the signal between the two devices only works within such relatively short distances. If
Place Scale in Final
Position and Press YES
when done
Enter Setup Wizard?
(Yes/No)
