Maintenance
HON 512 with HON 650 pilot user manual
138
Figure
Step
Description
5
Insert the filter insert (1), with the opening
facing downwards, into the body.
6
Take the base plate. Replace the O-ring
with a new, greased O-ring.
7
Put the base plate on the body. Tighten the
nuts (1) and washers (2) for the base plate
(3) in a criss-cross sequence. Observe the
tightening torque information provided in
the table before this section.
8
Unscrew the fittings and replace the
sealing rings (1) with new, greased ones.
9
Install the greased fittings back in place.
Observe the tightening torque information
provided in the table before this section.
Proceed as follows:
Reassembling the pilot
(see page 139)
Next task
Summary of Contents for HON 512
Page 185: ...Appendix HON 512 with HON 650 pilot user manual 185 X Fail to open version Y Amplifying valve ...
Page 205: ...Appendix HON 512 with HON 650 pilot user manual 205 ...
Page 206: ...Appendix HON 512 with HON 650 pilot user manual 206 ...
Page 207: ...Appendix HON 512 with HON 650 pilot user manual 207 ...
