CLSS Gateway - Installation and Users’ Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
101
CLSS Gateway Compatible Node Types
The BACnet Feature
8.6.6 Standard Object Types Supported—Notification Class
Write Property/Add List element required for Intrinsic Reporting.
Data Link Layer Options:
BACnet IP, (Annex J)
BACnet IP, (Annex J), Foreign Device
ISO 8802-3, Ethernet (Clause 7)
ANSI/ATA 878.1, 2.5 Mb. ARCNET (Clause 8)
ANSI/ATA 878.1, RS-485 ARCNET (Clause 8), baud rate(s):
MS/TP MASTER (Clause 9), baud rate(s):
MS/TP SLAVE (Clause 9), baud rate(s):
Point-To-Point, EIA 232 (Clause 10), baud rate(s):
Point-To-Point, modem, (Clause 10), baud rate(s):
LonTalk, (Clause 11), medium:
Other:
Device Address Binding:
Is static device binding supported? (This is currently necessary for two-way
communication with MS/TP slaves and certain other devices.)
Yes
No
Networking Options:
Router, Clause 6—List all routing configurations, e.g., ARCNET-Ethernet,
Ethernet-MS/TP, etc. BACnet to Proprietary ARCnet Fire Network
Annex H, BACnet Tunneling Router over IP BACnet Broadcast Management Device
(BBMD)
Does the BBMD support registrations by Foreign Devices?
Yes
No
Character Sets Supported:
Indicating support for multiple character sets does not imply that they can all be
supported simultaneously.
ANSI X3.4
IBM/Microsoft DBCS ISO 8859-1
ISO 10646 (UCS-2)
ISO 10646 (ICS-4)
JIS C 6226
8.6.7 Supported Non-BACnet Equipment/Networks
This product supports communications between NOTIFIER® Fire and Annuciator nodes
compatible with network v5.0 and later operating in a network or stand-alone
configuration.
8.7 CLSS Gateway Compatible Node Types
NOTE:
The CLSS Gateway requires that at least one node on the NFN network be an
ONYX series panel. The gateway does not operate on an NFN network with no ONYX
series panels.
