4
The Certified HEPA Filters and Odor Reducing Pre-Filter are supplied within the air purifier. New air purifiers have
their filters wrapped to ensure purity, and are labeled to help identify the proper replacement filter. (Type
Filter
R
Certified HEPA Filter; Type
A
Pre-Filter
Odor Reducing Pre-Filter)
• Before using your new air purifier you must remove the wrappers covering the filters and pre-filter. Make sure
the air purifier is OFF and unplugged. Press the two hand symbols ( ) on the front grille to release it from the
unit and pull the grille toward you to remove it (
see Fig. 2
). Grasp the sides of the filter frame near its top end
and pull outward. Repeat for the second and third filter if applicable.
• Remove protective wrap from the filters (including the pre-filter) that have
been supplied with your air purifier.
• Place the Certified HEPA filter(s)
Filter
R
into the air purifier housing. Ensure
that the removal “pull” tabs are facing outward (this will facilitate filter
removal later). Place the pre-filter on top of the HEPA filter(s). Tuck the
edges of the pre-filter into the tabs that are located around the edges of
where the HEPA filter(s) are inserted.
• Replace the front grille by placing the tabs on the bottom of the grille into
the slot(s) on the unit. Gently push the top of the grille into place by pressing
on the hand symbols ( ) to secure in place.
INSTALL CERTIFIED HEPA FILTERS AND ODOR REDUCING PRE-FILTER
NOTE:
This air purifier is an app enabled device. These instructions cover the operation of the air purifier
device only. For additional features available via the Honeywell Portable Air Purifier App, please reference the
instructions that are printed as a stand alone insert to this booklet.
OPERATION
SET-UP
• Select a firm, level, and flat location.
• When operating, large volumes of air are drawn toward the air purifier. Surrounding areas should be cleaned
and/or vacuumed frequently to prevent build-up of dust and other particles. This may also help prolong the
life of the filter. If the unit is placed on a light colored carpet, a small mat or rug should be used underneath
to prevent staining. This is especially important in homes with airborne particles from smoking, fireplaces, or
where candles are burned.
• Ensure the front of the unit faces away from the closest wall or furniture.
• Ensure no grilles are blocked.
Fig. 2
The energy efficiency of this ENERGY
STAR certified model is measured
based on a ratio between the model’s
CADR for Smoke and the electrical
energy it consumes, or CADR/Watt.
