Configuration
Rev 3.01
65
Document 900.0258
10/05
Caution
When you change the port settings you must also change the port
settings on a PC running RAS. Refer to the RAS User Guide for
detailed information.
6.
To save your changes and return to the Network Setup screen, highlight OK and
then press
#
. Select Cancel to exit the screen without saving the changes.
LAN Setup - DHCP
To set up a LAN (DHCP) connection:
1.
On the LAN Setup screen, highlight the box beside Type, then press
#
.
2.
Select DHCP, then highlight OK.
The system reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
Figure 3-46
LAN (DHCP) Setup Screen
LAN Setup - ADSL
Note
You cannot configure ADSL and modem at the same time. If the
DVR is networked via modem, the ADSL (PPPoE) option will not
be selected.
To set up a LAN ADSL connection:
1.
On the LAN Setup screen, highlight the box beside Type, then press
#
.
2.
Select ADSL (PPPoE), then highlight OK.
Summary of Contents for HRHD16+
