Operation Instruction
Technical Parameter
Flow rate
1.5 L/min
Filtration composition of cartridge
Granular active carbon, ultrafiltration membrane
Applicable inlet water pressure
0.07 MPa ---0.6 MPa
Rated total purified water
1500 L
Product gross weight
Dimension
Height 275 mm x Diameter 136.6 mm
Inlet water requirements
Municipal tap water, GB5749-2006 compliant
2
• Regularly check the water purifier and water pipe parts to ensure that there is no
water leakage;
• Drain water for 5-10 seconds if the water purifier has not been in use for 24 hours. If it
has not been used for more than 5 days (3 days in the case of summer), drain water
for 2 to 3 minutes before resuming usage. Once the cartridge is in use it cannot be
left idle for prolonged period of time, especially during summer. Generally the idling
period should not exceed 14 days. If so, change of cartridge is recommended;
• If filtered water is to be obtained and stored, pour it into a clean vessel and cover the
vessel tightly. Place the vessel in the refrigerator. Water stored in this manner may be
preserved for only two days.
• Immediately cut off the water inlet for the water purifier (by turning the water
segregator to “TAP” position) and promptly contact the service provider in any of the
following circumstances:
If there is water leakage for the water purifier’s pipe or relevant parts;
If there are other abnormal phenomena or breakdowns
1.54 Kg
* The rated total purified water volume is effective treatment volume spiked at full
process in accordance with of the Ministry of Health’s inspection provisions. The
actual treatment volume may vary according to the local water quality and usage
environment.
* Flow rate: The actual situation may vary according to the usage environment, water
pressure and water quality.
