Usage Method
Filtered water
Tap water
Switch
Water segregator
Electronic device and application
Setting net water purification volume for cartridge:
Instructions on Digital Panel
4
Turning on for the first time after installation:
1. Turn the tap to fully-opened position.
2. The water segregator switch is in a “Purified” (i.e. purified water) position. The water
will flow into the water purifier. Due carbon granules and air bubbles, the initial water
flow will show slight turbidity. This is normal.
3. Continue to flush the water purifier for about 10 minutes until the water is clear
without any air bubbles. The water can now be consumed.
Use the water segregator switch to select “PURIFIED” (purified water) or “TAP” (tap
water).
• When the water segregator is in the “PURIFIED” position, the water discharged is
purified water.
• When it is in the “TAP” position, the water discharged is municipal tap water.
Time (Day)
Flow rate (liter)
Button
Digital display
1) Under normal display status press the button for 3 seconds. The digital display will
flicker to indicate that it is in "Setting" mode. Release the button to enter the "Setting"
mode.
2) While in “Setting” mode the digital display will indicate the value last saved. The
default value is “1500”.
