63
Figure 5-61 Configure Trigger Profiles
New Profile
1. Click
New Profile
and click
in the pop-up “Alarm Device” window to add alarm
device.
2. Click on the added alarm device to select the trigger condition in the dropdown list;
3. Click
in “Triggered Device” window to add triggered device, as shown in the
following figure:
Figure 5-62 Add Alarm Device and Triggered Device
4. Configure the added device in “Camera Settings” window. To remove a device, select
that row and click
Remove
, as shown in the following figure:
Figure 5-63 Camera Settings
5. Configure “Alarm Output”, “Show Message” and “Audible Alarm” in “System Settings”
window as the figure below:
Figure 5-64 System Settings
6. Set Pre-Recording and Post-Recording:
Pre-Recording
—starts recording a few
seconds before triggered alarms;
Post-Recording—
continues recording a few seconds
after the alarm event occurs.
