HVAC400X – APPLICATION MANUAL
EN2B-0417GE51 R0719
110
PROGRAMMING IN THE GRAPHICAL DISPLAY
1.
Select a parameter. To go into the Edit mode, push the
RIGHT arrow button.
2.
In the Edit mode, the slot value
DigIN SlotA
is underlined
and blinks. If you have more digital inputs available in your
I/O, e.g., because of option boards in slots C, D or E, make
a selection of them.
3.
To enter into the parameter, press the OK button, which
will then start to blink.
4.
To change the terminal to 6, push the UP arrow button
three times. Accept the change using the OK button.
STOP
Digital Inputs
ID: 405
Ext Fault Close
Ext Fault Open
Fault Reset Close
DigINSlotA.3
DigINSlot0.2
DigINSlotA.6
P3.5.1.7
READY
I/O
STOP
Ext Fault Close
ID: 405
P3.5.1.7
READY
I/O
DigIN SlotA.3
Min:
Max:
STOP
Ext Fault Close
ID: 405
P3.5.1.7
READY
I/O
DigIN SlotA.3
Min:
Max:
STOP
Ext Fault Close
ID: 405
P3.5.1.7
READY
I/O
DigIN SlotA.6
Min:
Max: