HW7500E/HW7500EL Portable Electrical Generator Owner’s Manual
www.honeywellgenerators.com
7
Assembly
Step 1: Install Support Legs
1.
Place the generator on a flat, level surface.
2.
Stand at side of generator
opposite
recoil starter
handle. Grip frame; carefully pull up and push to tilt
generator backward.
3.
Gently set generator onto the recoil side or elevate
the generator by placing solid wood pieces under-
neath unit.
4.
Place a washer in the center of each rubber stopper.
5.
Attach a rubber stopper to the bottom of each support
leg using a 30 mm long hex flange bolt and a serrated
flange nut; tighten until securely seated.
6.
Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm long full-thread hex
flange bolts and serrated flange nuts; tighten until
securely seated.
To install support legs, you will need:
M8 x 30 mm long hex flange bolts (2)
M8 x 16 mm OD x 1.5 mm washers (2)
M8 serrated flange nuts (6)
M8 x 16 mm long full-thread hex flange bolts (4)
Brackets (2)
Rubber stoppers (2)
Socket wrench with 13 mm socket
*
*
Not included
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
FIGURE 5:
Tip onto Generator Recoil Side
CAUTION
FIGURE 6:
Rubber Stopper Attached to Support Leg
FIGURE 7:
Support Leg Attached to Generator
Summary of Contents for HW7500E - Portable Generator NOT
Page 99: ... ...
